Policy Map in cisco 2960

[rsavena14]

Hi All,

I tried configuring policy-map in a fastethernet 0/1 switchport on a cisco 2960 switch. But the configuration doesn't take effect. Once i move the policy-map to the interface vlan it's giving me an error that policy-map cannot be configured on a vlan.

access-list 101 permit any any log

class-map voice

match access-group 101

policy-map mark

class voice

set dscp ef

FastEthernet 0/1

service-policy input mark

If I do a show access-list 101 i do not see any increments. Is it possible to do this policy-map in a layer 2 port or should it be done on a routed port?

[paolo bevilacqua]

Are you using cisco phones or other decent vendor? They set dscp EF by default and there is no need to rewrite.

[rsavena14]

I am using cisco phone for testing. But my goal is to confirm if policy-map is possible  or not to do marking on a switchport.

[paolo bevilacqua]

It is possible.

Please remember to rate useful posts clicking on the stars below.