Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Policy routing problem

Q:- If you have configured route redistribution between separate routing domains and have included route filters to prevent route feedback, which command would you use on a boundary router to verify that redistribution is working correctly?

A. show ip protocols

B. trace

C. show ip access-lists

D. ping

Q:- On Cisco routers, fast switching of policy-based routing _____.

A. is not supported

B. requires the ip fast policy interface configuration command

C. requires the ip fast policy router configuration command

D. requires the ip route-cache policy router configuration command

E. requires the ip route-cache policy interface configuration command

Regards

Mahi

4 REPLIES

Re: Policy routing problem

Question 1 is "show ip protocols"

Question 2 I've got to look up but for some reason i want to say the answer is (A)

Can someone give a crack at question 2 and give us a firm answer.

Patrick

Community Member

Re: Policy routing problem

Community Member

Re: Policy routing problem

Hi,

For first question A is not a correct answer... But i don,t know the correct one..

Kindly help me out...

Regards

Mahi

Purple

Re: Policy routing problem

Mahi,

I believe the answer should be B. The reason is that a traceroute will show you the presence of a routing loop, which is a frequent result of route feedback when redistributing protocols.

Hope that helps - pls do remember to rate posts that help.

Paresh

181
Views
5
Helpful
4
Replies
CreatePlease to create content