I'm working on a MAN project. The client has 3560s at the remote location and 6500s at the Hubs. The Fiber runs in a ring from each individual location back to one of the hub sites. So, the 3560 may have an LX GBIC in one port and a ZX GBIC in the other, based on the distance from the hub site going east and west.
My question is; Can I port channel these two Gigabit ports and if I do, will I see errors based on the fistance difference?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...