I have modified a building network to be PABP compliant (Visa) where two router and two subnets are required.
My original building network configuration was set-up to enable remote access to a terminal server via port forwarding on an RVS4000 router. Thus cable modem -> wan xx.xx.xx.xx ROUTER lan 192.168.1.1 -> Subnet 192.168.1.0 with Port Forwarding TCP 3389 to 192.168.1.11 (terminal server).
The new network configuration is composed of two RVS4000 routers on two subnets. Thus Cable Modem -> wan xx.xx.xx.xx ROUTER1 lan 192.168.2.2 -> Subnet 192.168.2.0 -> DMZ 192.168.2.14 and second router wan 192.168.2.1 ROUTER2 lan 192.168.1.1 -> Subnet 192.168.1.0.
Router1 is configured in gateway mode and Router2 is configured in router mode. Port forwarding on Router1 for TCP port 3389 is to 192.168.2.1 (wan port on Router2). Where as port forwarding on Router 2 for TCP port 3389 is to 192.168.1.11 (terminal server address).
With this new network configuration I am no longer able to connect to the Terminal Server remotely. No problem gaining access to the Internet and subnet 192.168.2.0 from inside subnet 192.168.1.0.
Thus I think my problem is port forwarding through the two RVS4000 routers. Any assistance with this problem will be much appreciated.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...