06-09-2006 08:34 AM - edited 03-03-2019 12:57 PM
Is there a way to monitor a serial port on a 3845 router. I want to attach a protocol analzer to check network traffice
06-09-2006 10:00 AM
You would have to put the device inline. If you have a trunk from a switch to your router that ends up passing all the traffic you are interested in, you could just do a monitor session on the switch port. Hope this helps.
06-09-2006 11:36 AM
Is there no way to monitor a serial port
06-09-2006 11:56 AM
you can have debug command on serial interface...
the following link will show you various debug command...
but debugs are cpu intensives
hope this helps
rate this post if it helps
regards
Devang
06-09-2006 11:36 AM
Is there no way to monitor a serial port
06-09-2006 11:01 AM
switches are having capability to configure their port as switch port analyser SPAN...where you can connect the host with the capturing or analzer which capture the packet and show you the various statics of packets so you can try it out by creating such a topology but still have problem for serial port...
hope this will help you
rate this post if it helps
regards
Devang
06-09-2006 12:59 PM
There is not a way to monitor the serial port for what you are wanting to do.
06-09-2006 01:46 PM
Unless you want to get creative and policy route your traffic out and back in a ethernet port or do some nasty bridging you will need a real serial analzer to get into a serial line.
If you turn on ip route-cache flow on the serial port you will get some basic information about ip addresses paris and ports used. I don't think there is a way to get the payload with a router command..
06-11-2006 12:28 PM
There is a new feature in IOS that should make this possible. The feature is IP Traffic Export and was introduced in 12.3(4)T. I have not used this feature myself and so can not say from experience how well it works. But the documentation claims that it exports traffic onto a LAN interface where the traffic may have arrived on LAN or WAN interfaces. So it sounds exactly like what the original post wants to do.
This link should be information to get you going:
http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a0080455b94.html
My thanks to Sundar who originally pointed this out.
HTH
Rick
06-12-2006 06:09 AM
Rick thanks to you and Sundar this sounds the most promising. I have downloaded the article and will try it today.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide