Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

POS Interface Config

Has anybody got any good config for a point to point stm1 link using a POS interface on each side (PA-POS-1OC3)?

1 REPLY
New Member

Re: POS Interface Config

Hi,

You can use something like this:

interface POS5/1/0

ip address 146.x.x.25 255.255.255.252

ip pim sparse-dense-mode

encapsulation ppp

no keepalive

clock source internal

end

interface POS1/0

description OC3 to MGOR1-POS5/1/0

ip address 146.x.x.26 255.255.255.252

ip pim sparse-dense-mode

encapsulation ppp

no keepalive

end

On the following link you'll find clocking recommendations for your POS interfaces:

http://www.cisco.com/warp/customer/127/POS/posclocking_16181.html

Hope it helps!

Regards,

Juan

185
Views
0
Helpful
1
Replies
CreatePlease to create content