Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

POS WAN Interfaces on 7600 Series Routers

Is there a command to see the received bandwidth of a

POS interface on a 7600?  I know with a HSSI type interface I can type show controllers and I'll see the received throughput, ie 20Mb on a fractional DS3.  I cannot seem to find a way to do this on a POS interface.  If I order a fractional 200Mb OC12 POS circuit, how can I tell the bandwidth is actually 200Mb without actually pushing that much traffic through it?  Appreciate any insight on this one.

/r

Rob

1 REPLY
New Member

Re: POS WAN Interfaces on 7600 Series Routers

hello,

sorry to ask you question back , by seeing the attached doc , can you tell me what is the BW on this link its again the fractional DS-3link

325
Views
0
Helpful
1
Replies
CreatePlease to create content