I was wondering if I could use PPP encap to combine 2 T1 lines on a 2611 router.
My config on the routers are:
interface FastEthernet0/0
description connection to DMZ switch
ip address xxx.15.0.2 255.255.255.252
ip helper-address 10.0.60.2
duplex auto
speed auto
!
interface Serial0/0
description connection to DSU to Corpus
ip address xxx.15.0.5 255.255.255.252
service-module t1 fdl both
!
interface FastEthernet0/1
description NMLI connection 106 Wynn
ip address xxx.26.1.1 255.255.255.252
ip helper-address 10.0.60.2
speed 100
full-duplex
the IOS version is 12.2(8)T10 and the routers have the following hardware:
cisco 2611XM (MPC860P) processor (revision 0x100) with 93184K/5120K bytes of memory.
Processor board ID JAE074002B7 (1945669642)
M860 processor: part number 5, mask 2
Bridging software.
X.25 software, Version 3.0.0.
2 FastEthernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
I know I will have to purchase another T1 DSU/CSU WIC but I was wondering if I could use the following configuration:
interface Serial0/0:0
no ip address
encapsulation ppp
ppp multilink
ppp multilink group 1
!
interface Serial1/1:0
no ip address
encapsulation ppp
ppp multilink
ppp multilink group 1
interface Multilink1
ip address x.x.x.x
ppp multilink
ppp multilink group 1
