Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PPP Multilink

Hi,

Is it possible to configure a ppp multilink using a NM-CEM-4TE1 card on cisco router 2821?

I have tried and can't find the command.

Any help would be appreciated

1 REPLY

Re: PPP Multilink

I'm not sure about the actual card number, but to create a multilink the commands are:

int s0/0

encaps ppp

no ip address

ppp multilink

ppp multilink group 1

int s0/1

encaps ppp

no ip address

ppp multilink

ppp multilink group 1

int multilink1

ip address x.x.x.x 255.255.255.x

ppp multilink

ppp multilink group 1

That should be all you need to get them bonded.

HTH,

John

HTH, John *** Please rate all useful posts ***
109
Views
0
Helpful
1
Replies
CreatePlease to create content