I have a router (RouterB) that is not receiving LCP CONFACK messages from the sending router (RouterA). RouterB is sending a CONFREQ, RouterA is receiving it and sending a CONFACK to RouterB, but B never gets it. It is not getting any inbound messages for that matter. I had the provider test the T1 and it runs clean. Serial ports on both sides are up.
Not sure where to look next. Any suggestions?
RouterA - 1760 - 12.2(4)
CLE_1760_PPP#sh int s0/0
Serial0/0 is up, line protocol is down
Hardware is PQUICC with Fractional T1 CSU/DSU
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
reliability 253/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP Listen, multilink Closed
Closed: CDPCP, loopback not set
Last input 00:00:29, output 00:00:29, output hang never
Last clearing of "show interface" counters 06:26:26
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...