Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Cisco Employee

PPP Over farme-relay

Hi Team,

I was working on PPP over FR other day and somehow, I couldnt get it setup and working properly.

here is the setup :

R1 --- FR---R2, using physical interfaces.

R1 config:

username R2 password cisco

int virtual-template 1

ip add 10.1.1.1 255.255.255.0

encap ppp

ppp auth chap

int s 0/0

encap frame

frame int-dlci 102 ppp virtual-temp 1

R2 config:

username R1 password cisco

int virtual-template 1

ip add 10.1.1.2 255.255.255.0

encap ppp

ppp auth chap

int s 0/0

encap frame

frame int-dlci 201 ppp virtual-temp 1

Fr PVC status= UP

Virtualtemplate= Down, Which is OK as it will always be down/down

Virtual access 2 = Down

PPP status: LCP down, Closed.

Any inputs on this would be appreciated.

Regards,

-amit singh

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: PPP Over farme-relay

If it doesn't work, turn debugging on ppp authentication.

Rack1R1#debug ppp authen

PPP authentication debugging is on

Rack1R1#conf t

Enter configuration commands, one per line. End with CNTL/Z.

Rack1R1(config)#int s1/0

Rack1R1(config-if)#shut

Rack1R1(config-if)#end

Rack1R1#

*Mar 1 00:22:30.887: %LINK-5-CHANGED: Interface Serial1/0, changed state to administratively down

*Mar 1 00:22:30.895: %LINK-3-UPDOWN: Interface Virtual-Access2, changed state to down

Rack1R1#

*Mar 1 00:22:31.087: %SYS-5-CONFIG_I: Configured from console by console

*Mar 1 00:22:31.887: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1/0, changed state to down

*Mar 1 00:22:31.895: %LINEPROTO-5-UPDOWN: Line protocol on Interface Virtual-Access2, changed state to down

Rack1R1#conf t

Enter configuration commands, one per line. End with CNTL/Z.

Rack1R1(config)#int s1/0

Rack1R1(config-if)#no shut

Rack1R1(config-if)#end

Rack1R1#

*Mar 1 00:22:42.271: %SYS-5-CONFIG_I: Configured from console by console

*Mar 1 00:22:43.047: %LINK-3-UPDOWN: Interface Serial1/0, changed state to up

*Mar 1 00:22:43.075: %LINK-3-UPDOWN: Interface Virtual-Access2, changed state to up

*Mar 1 00:22:43.079: Vi2 PPP: Using default call direction

*Mar 1 00:22:43.083: Vi2 PPP: Treating connection as a dedicated line

*Mar 1 00:22:43.087: Vi2 PPP: Session handle[7000023] Session id[40]

*Mar 1 00:22:43.087: Vi2 PPP: Authorization required

*Mar 1 00:22:43.335: Vi2 CHAP: O CHALLENGE id 40 len 23 from "R1"

*Mar 1 00:22:43.439: Vi2 CHAP: I CHALLENGE id 40 len 23 from "R2"

*Mar 1 00:22:43.451: Vi2 CHAP: Using hostname from interface CHAP

*Mar 1 00:22:43.451: Vi2 CHAP: Using password from AAA

*Mar 1 00:22:43.455: Vi2 CHAP: O RESPONSE id 40 len 23 from "R1"

*Mar 1 00:22:43.459: Vi2 CHAP: I RESPONSE id 40 len 23 from "R2"

Rack1R1#

*Mar 1 00:22:43.467: Vi2 PPP: Sent CHAP LOGIN Request

*Mar 1 00:22:43.475: Vi2 PPP: Received LOGIN Response PASS

*Mar 1 00:22:43.483: Vi2 PPP: Sent LCP AUTHOR Request

*Mar 1 00:22:43.487: Vi2 PPP: Sent IPCP AUTHOR Request

*Mar 1 00:22:43.495: Vi2 LCP: Received AAA AUTHOR Response PASS

*Mar 1 00:22:43.499: Vi2 IPCP: Received AAA AUTHOR Response PASS

*Mar 1 00:22:43.503: Vi2 CHAP: O SUCCESS id 40 len 4

*Mar 1 00:22:43.623: Vi2 CHAP: I SUCCESS id 40 len 4

*Mar 1 00:22:43.635: Vi2 PPP: Sent IPCP AUTHOR Request

Rack1R1#

*Mar 1 00:22:44.047: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1/0, changed state to up

*Mar 1 00:22:44.623: %LINEPROTO-5-UPDOWN: Line protocol on Interface Virtual-Access2, changed state to up

4 REPLIES
Hall of Fame Super Bronze

Re: PPP Over farme-relay

If the router's hostname isn't R1 and R2, you must send the hostname in chap with

ppp chap hostname

command.

BTW, I copied and pasted your config and worked here - the only thing I changed was adding the ppp chap hostname since my router's hostname wasn't R1 and R2.

Cisco Employee

Re: PPP Over farme-relay

Thanks Edison for the reply.

I think my hostname was the same as used in the UN/PW. let me go ahead check it right away and will rate the post. Thanks buddy !!

-amit singh

Hall of Fame Super Bronze

Re: PPP Over farme-relay

If it doesn't work, turn debugging on ppp authentication.

Rack1R1#debug ppp authen

PPP authentication debugging is on

Rack1R1#conf t

Enter configuration commands, one per line. End with CNTL/Z.

Rack1R1(config)#int s1/0

Rack1R1(config-if)#shut

Rack1R1(config-if)#end

Rack1R1#

*Mar 1 00:22:30.887: %LINK-5-CHANGED: Interface Serial1/0, changed state to administratively down

*Mar 1 00:22:30.895: %LINK-3-UPDOWN: Interface Virtual-Access2, changed state to down

Rack1R1#

*Mar 1 00:22:31.087: %SYS-5-CONFIG_I: Configured from console by console

*Mar 1 00:22:31.887: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1/0, changed state to down

*Mar 1 00:22:31.895: %LINEPROTO-5-UPDOWN: Line protocol on Interface Virtual-Access2, changed state to down

Rack1R1#conf t

Enter configuration commands, one per line. End with CNTL/Z.

Rack1R1(config)#int s1/0

Rack1R1(config-if)#no shut

Rack1R1(config-if)#end

Rack1R1#

*Mar 1 00:22:42.271: %SYS-5-CONFIG_I: Configured from console by console

*Mar 1 00:22:43.047: %LINK-3-UPDOWN: Interface Serial1/0, changed state to up

*Mar 1 00:22:43.075: %LINK-3-UPDOWN: Interface Virtual-Access2, changed state to up

*Mar 1 00:22:43.079: Vi2 PPP: Using default call direction

*Mar 1 00:22:43.083: Vi2 PPP: Treating connection as a dedicated line

*Mar 1 00:22:43.087: Vi2 PPP: Session handle[7000023] Session id[40]

*Mar 1 00:22:43.087: Vi2 PPP: Authorization required

*Mar 1 00:22:43.335: Vi2 CHAP: O CHALLENGE id 40 len 23 from "R1"

*Mar 1 00:22:43.439: Vi2 CHAP: I CHALLENGE id 40 len 23 from "R2"

*Mar 1 00:22:43.451: Vi2 CHAP: Using hostname from interface CHAP

*Mar 1 00:22:43.451: Vi2 CHAP: Using password from AAA

*Mar 1 00:22:43.455: Vi2 CHAP: O RESPONSE id 40 len 23 from "R1"

*Mar 1 00:22:43.459: Vi2 CHAP: I RESPONSE id 40 len 23 from "R2"

Rack1R1#

*Mar 1 00:22:43.467: Vi2 PPP: Sent CHAP LOGIN Request

*Mar 1 00:22:43.475: Vi2 PPP: Received LOGIN Response PASS

*Mar 1 00:22:43.483: Vi2 PPP: Sent LCP AUTHOR Request

*Mar 1 00:22:43.487: Vi2 PPP: Sent IPCP AUTHOR Request

*Mar 1 00:22:43.495: Vi2 LCP: Received AAA AUTHOR Response PASS

*Mar 1 00:22:43.499: Vi2 IPCP: Received AAA AUTHOR Response PASS

*Mar 1 00:22:43.503: Vi2 CHAP: O SUCCESS id 40 len 4

*Mar 1 00:22:43.623: Vi2 CHAP: I SUCCESS id 40 len 4

*Mar 1 00:22:43.635: Vi2 PPP: Sent IPCP AUTHOR Request

Rack1R1#

*Mar 1 00:22:44.047: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1/0, changed state to up

*Mar 1 00:22:44.623: %LINEPROTO-5-UPDOWN: Line protocol on Interface Virtual-Access2, changed state to up

Cisco Employee

Re: PPP Over farme-relay

It has worked for me without the "PPP Chap hostname ". I dont know what I missed out earlier, but its working for me now. :-)

-amit singh

123
Views
0
Helpful
4
Replies
CreatePlease login to create content