Oh, I see now what you had on your mind. Thanks for clarifying.
Regarding the native VLAN support - surely, the HWIC-4ESW does support the native VLAN. But I am not sure how that would actually help to solve the original post - the author seems to simply want connect two ISPs to the same router and have two different IP subnets to talk to the respective routers.
The HWIC-4ESW is a Layer2 switching module only. It does not support the no switchport command to make a port to be routed (note that even in multilayer switches supporting this command, it merely creates an internal separate VLAN allocated from the extended range for each such port and silently attributes the port to it). The IP address therefore cannot be connfigured on a port of the HWIC module directly.
Again not being clear - if the module supports no vlans = native vlan, then the 2 interfaces can either be bound to 1 interface (say loopback or Bridge) then the 2 x isp modems can have the "same" internal IP addresing scheme facing the router.
Or the router can either be configured with HSRP or just an IP SLA to either provide failover or PBR to take advantage of having 2 x ISP links.
I suppose my posts are more of a deisgn fix, rather than fixing the current design.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.