Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PPPoE Over IEEE 802.1Q VLANs in 12.4T

I am trying to configure PPPoE Over IEEE 802.1Q VLan on a 2811 router with (C2800NM-SPSERVICESK9-M), Version 12.4(24)T8

PPPoE client on FastEthernet0/0 works fine.

interface FastEthernet0/0
 no ip address
 duplex auto
 speed auto
 pppoe enable group global
 pppoe-client dial-pool-number 1

But PPPoE session is not established on a subinterface with encapsulation dot1Q. It is not even trying to connect to the PPPoE server.

Cisco Feature Navigator says that this feature was added in 12.4T.

Can anybody confirm that 'PPPoE over IEEE 802.1Q VLANs' feature works fine on this IOS?

Thank you in advance!

5 REPLIES
New Member

Does anyone has 'PPPoE over

Does anyone has 'PPPoE over 802.1Q VLANs' feature configured on 2800 series router?

Hi there,Have you tried

Hi there,

Have you tried debugging using debug ppp negotiation.

 

This output is too verbose so better dont do it on console and check what do you see in the logs.

 

HTH

Hitesh

New Member

Yes. However there is nothing

Yes. However there is nothing in the debug ppp negotiation output whilst PPPoE is configured on the subinterface Fa0/0.2. As soon as I back to the Fa0/0 debug show me the standard PPP negotiation proccess and then PPPoE becomes active successfully.

Hi there,What feature are you

Hi there,

What feature are you running on the router? can you confirm?

also are you using vpdn group of bba group?

Thanks

Hitesh

New Member

Below works fine.

Below works fine.

vpdn enable
!
vpdn-group 1
 request-dialin
  protocol pppoe
bba-group pppoe global

 

interface FastEthernet0/0
 no ip address
 duplex auto
 speed auto
 pppoe enable group global
 pppoe-client dial-pool-number 1

But the same doesn't work over the subinterface:

interface FastEthernet0/0.2
 encapsulation dot1Q 2
 pppoe enable group global
 pppoe-client dial-pool-number 1

 

184
Views
0
Helpful
5
Replies