Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

pppoe relay and per-user vpdn for service selection

Hi,

   I have a LAC for pppoerelay session from my customer. I have an LNS that terminate L2TP tunnel and for the authentication of customer. This configuration works.

Now, I would like to do a  'service selection' based on the domain in the username.

So I change my configuration and add "domain" in "vpdn-group" (see below) in the LAC.

The question is that this command is ignored and I can pass using different domains.

Regards

Gianrico Fichera


This is my LAC configuration:

!

subscriber profile gianrico

service relay pppoe vpdn group miovpngroup

!

!

vpdn enable

!

vpdn-group miovpngroup

request-dialin

  protocol l2tp

domain mydomain.org                                        <-- It seems that this is ignored in this specific configuration (pppoerelay I mean)

initiate-to ip 192.168.100.1

source-ip 192.168.100.12

l2tp tunnel password 0 mypassword

!

!

bba-group pppoe MYPPPOEGROUP

virtual-template 1

service profile gianrico

!

!

interface FastEthernet0/0

description --- WAN SIDE ---

ip address 192.168.100.12 255.255.255.0

duplex auto

speed auto

!

interface FastEthernet0/1

description --- customer side ---

ip address 192.168.40.2 255.255.255.0

duplex auto

speed auto

pppoe enable group MYPPPOEGROUP

!

interface Virtual-Template1

ip unnumbered FastEthernet0/0

ppp authentication pap chap

ppp chap hostname myhostname

435
Views
0
Helpful
0
Replies
CreatePlease to create content