I have a router configured for both routing protocols (OSPF/EIGRP)...EIGRP is configured on the Frame Relay interface and OSPF is configured on an MPLS interface. I am not doing ANY redistribution...I have added MPLS to this router but still want to keep Frame as backup.
Whenever I have both routing protocols up and running, EIGRP takes over due to AD. I have used the distance command under the OSPF process to specify a better AD than EIGRP but EIGRP still takes over.
I want to have both up and running and EIGRP used as backup in the event OSPF is down.
I would like to get some ideas of what my best options are.
I tried changing this morning so that I have the same summary routes being received from FRAME and MPLS. I would like to just receive the summary routes on both interfaces, but EIGRP is still showing specific routes. I haven't done anything (distribute-list, ip summary-address, etc..) on the other end of the Frame Relay link.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...