Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Previously Entered IOS Commands Missing from Sh Run Output

On more than one occasion my colleagues and I have noticed that commands successfully accepted on interfaces don't show up in the show run output, i.e. I have put ip hello-interval eigrp 11 60 and ip hold-timer eigrp 11 180 on GRE tunnel interfaces on my branch 3725 router and my Core 6500 router. On occasion, I will not see the commands on the interface when I enter a show run. Is this a bug of the 122.33. SXF?

1 REPLY
Hall of Fame Super Silver

Re: Previously Entered IOS Commands Missing from Sh Run Output

Hello Matthew,

EIGRP defaults to hello 60 seconds hold 180 seconds on multipoint interface with bandwidth <= T1.

if the GRE is considered multipoint and BW is less then T1 the values are not showed because they are the default values.

Are you using multipoint GRE with DMVPN ?

Hope to help

Giuseppe

98
Views
0
Helpful
1
Replies
CreatePlease to create content