Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

pri and bri config

Hi,

        I have one 2851 router with HWIC-2CE1T1-PRI at HO side and three 1841 at branch side with bri and serial interfaces . i want to configure lease line as a primariry and isdn pri /bri as a backup link . HO and branch are point to point .I am new in these kind of setup so pls give me some examples or technotes . ASAP

Regards

Mak

1 REPLY

Re: pri and bri config

Hi,

        I have one 2851 router with HWIC-2CE1T1-PRI at HO side and three 1841 at branch side with bri and serial interfaces . i want to configure lease line as a primariry and isdn pri /bri as a backup link . HO and branch are point to point .I am new in these kind of setup so pls give me some examples or technotes . ASAP

Regards

Mak

Hi Mak,

Check out the below link hope this helps !!

http://www.cisco.com/en/US/tech/tk713/tk237/technologies_configuration_example09186a00800a3b77.shtml

Ganesh.H

If helpful do rate the post

224
Views
0
Helpful
1
Replies
CreatePlease to create content