cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2034
Views
9
Helpful
4
Replies

PRI flapping

burleyman
Level 8
Level 8

I am getting the following in my logs any ideas as to what could be causing this?

Apr 29 11:57:02.238 EDT: %CONTROLLER-5-UPDOWN: Controller T1 3/0, changed state to down (RAI detected)

Apr 29 11:57:02.242 EDT: %ISDN-6-LAYER2DOWN: Layer 2 for Interface Se3/0:23, TEI 0 changed to down

Apr 29 11:57:04.238 EDT: %LINK-3-UPDOWN: Interface Serial3/0:23, changed state to down

Apr 29 11:57:04.238 EDT: %CONTROLLER-5-UPDOWN: Controller T1 3/0, changed state to up

Apr 29 11:57:04.342 EDT: %ISDN-6-LAYER2UP: Layer 2 for Interface Se3/0:23, TEI 0 changed to up

Apr 29 11:57:06.242 EDT: %LINK-3-UPDOWN: Interface Serial3/0:23, changed state to up

Mike

4 Replies 4

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello Mike,

there was a problem on the T1 line with alarm RAI = Remote Alarm Indicator detected then the alarm was withdrawn and the controller and line came up again.

If this has happened many times you should call the ISDN provider and ask them to verify the line.

Hope to help

Giuseppe

Thanks for the reply. That is what I thought. I have not done a lot of troubleshooting with PRI's and I just wanted to make sure I was not missing something.

Mike

Thanks...those look good. I have saved them.

Mike

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: