Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PRI - ISDN switch type - primary-ni2c

I tried to configure a 2920 with a WIC=HWIC-1CE1T1-PRI. In the serial 0/0/0:23 I set the isdn switch type to primary-ni2c. When I then exit configure mode and show interface se0/0/0:23 the switch type has been changed to primary-ni. Is this normal?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: PRI - ISDN switch type - primary-ni2c

Yes, all the NI variants are, in fact, the same thing.

1 REPLY
Hall of Fame Super Gold

Re: PRI - ISDN switch type - primary-ni2c

Yes, all the NI variants are, in fact, the same thing.

1018
Views
0
Helpful
1
Replies