Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

pri states

what happens if one channel on a PRI is set to maintenance.

i ran a debug on one of my cisco voice gateway terminated 4 pris and users were experiencing fast busy when trying to call outbound....

Channel ID i = 0xE9808397

Exclusive, Interface 0, Channel 23

1019249: Oct 17 09:03:00 PDT: ISDN Se4/0:23 Q931: RX <- RELEASE_COMP pd = 8 cal

lref = 0x8C4A

Cause i = 0x83B6 - Incoming calls are barred

1019250: Oct 17 09:03:00 PDT: ISDN Se4/0:23 Q931: RX <- SERVICE pd = 3 callref

= 0x00

Change Status i = 0xC1 - maintenance

Channel ID i = 0xE9808397

Theseare the supported state values:

0--In service

1--Maintenance

2--Out of service

2 REPLIES
New Member

Re: pri states

Could you paste debug isdn q931 and debug voice ccapi inout at the same time.

It looks like DSp failed, try reboot.

New Member

Re: pri states

I did not run at the time a debug voice ccapi inout command what does it accomplish?

147
Views
0
Helpful
2
Replies
CreatePlease to create content