Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PRI to Catalyst to an IOS T.38 GW question

Hi,

The PRI are on a catalyst 6608-T1. I was told that I need make the PRI terminated on the 6608 be forwarded (only fax calls) to the Router(T.38 GW) by connecting a MFT-T1 card(router GW) to the 6608-T1...

Simple diagram:

T1 PRI T1

PRI ---> 6608 <--- Router

Fax calls are forwarded to Router (T.38 GW)

I'd prefer to just move the T1 PRI lines directly to the router to avoid having to make the PRI on the catalyst and router communicate, but the customer insists on having the PRI on catalyst.

Is there documentation fitting this scenario? Im at a loss...

TIA,

-Fred

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: PRI to Catalyst to an IOS T.38 GW question

1 REPLY
Silver

Re: PRI to Catalyst to an IOS T.38 GW question

121
Views
0
Helpful
1
Replies