I have two cisco 2811 routers located in different location connected through IP. I have one Data card printer in one side connected to router Asynchronous Serial port using line( serial db9), another side i have a server which is connected in same way ( Asyn serial - COM (DB9) that doesn't support for IP . I need to print from the server to the printer using reverse telnet mechanism how can I make this successful.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...