01-20-2009 01:20 PM - last edited on 03-25-2019 03:21 PM by ciscomoderator
Greetings i have a Cisco2801 ISR with G.SHDSL HWIC installed, it has the following QoS/ATM configuration at present however when i try to apply the policy to the ATM subinterface it wont stick, we are running 12.4(21)Advanced security, the strange thing is that i dont receive any error messages indicating as to why the policy apply, any suggestions would be much appreciated.
controller DSL 0/1/0
mode atm
line-term cpe
line-mode auto
dsl-mode shdsl symmetric annex B
!
class-map match-any Voice-Media
match ip dscp ef
class-map match-any Voice-Signalling
match ip dscp cs3
match ip dscp af31
!
!
policy-map SDSL-WAN-OUT
class Voice-Media
priority 256
class Voice-Signalling
bandwidth 8
class class-default
set ip dscp default
fair-queue
!
interface ATM0/1/0
no ip address
no atm ilmi-keepalive
!
interface ATM0/1/0.1 point-to-point
bandwidth 2048
pvc 0/38
encapsulation aal5mux ppp dialer
dialer pool-member 1
**Trying to insert Service Policy here**
!
Regards
Solved! Go to Solution.
01-20-2009 02:45 PM
01-20-2009 02:45 PM
Hi,
insert the policy under the PPP dialer interface.
01-20-2009 04:59 PM
Thank you for that, i had tried the same previously but it reported an error stating that there wasnt enough free bandwidth on the link, i forgot to add the "bandwidth" statement under the dialer interface.
All is working now, thank you for your time.
Regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: