Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Problem Applying QoS Policy to ATM Interface

Greetings i have a Cisco2801 ISR with G.SHDSL HWIC installed, it has the following QoS/ATM configuration at present however when i try to apply the policy to the ATM subinterface it wont stick, we are running 12.4(21)Advanced security, the strange thing is that i dont receive any error messages indicating as to why the policy apply, any suggestions would be much appreciated.

controller DSL 0/1/0

mode atm

line-term cpe

line-mode auto

dsl-mode shdsl symmetric annex B

!

class-map match-any Voice-Media

match ip dscp ef

class-map match-any Voice-Signalling

match ip dscp cs3

match ip dscp af31

!

!

policy-map SDSL-WAN-OUT

class Voice-Media

priority 256

class Voice-Signalling

bandwidth 8

class class-default

set ip dscp default

fair-queue

!

interface ATM0/1/0

no ip address

no atm ilmi-keepalive

!

interface ATM0/1/0.1 point-to-point

bandwidth 2048

pvc 0/38

encapsulation aal5mux ppp dialer

dialer pool-member 1

**Trying to insert Service Policy here**

!

Regards

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Problem Applying QoS Policy to ATM Interface

Hi,

insert the policy under the PPP dialer interface.

2 REPLIES
Hall of Fame Super Gold

Re: Problem Applying QoS Policy to ATM Interface

Hi,

insert the policy under the PPP dialer interface.

New Member

Re: Problem Applying QoS Policy to ATM Interface

Thank you for that, i had tried the same previously but it reported an error stating that there wasnt enough free bandwidth on the link, i forgot to add the "bandwidth" statement under the dialer interface.

All is working now, thank you for your time.

Regards

219
Views
0
Helpful
2
Replies
CreatePlease to create content