Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem in config ... E1

Hi

I have multi service E1 card

The problem which i face is that i config. E1 for Pri frist (isdn). after that i config it (E1) same E1 for channel group.

after negating the pri Commands Router messeges that it will take effect after reload.

so reload is problem. suggest me shuold i reload the router or there is any other solutons.

Thanks

1 REPLY

Re: Problem in config ... E1

When the router says it needs a reload, there is little alternative. Pick a suitable time or.. (not utterly professional) let it happen by accident! ;-)

Regards,

Leo

96
Views
0
Helpful
1
Replies
CreatePlease to create content