Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem in configuring port-channel between nexus and 3760 switch

Hi,

i am facing problem in bring up the port-channel between the nexus 7k series swich and cisco 3760 L3 switch.

does this possible at the first place and of possiable what could be the problem that shoping then to come up

Regards

Logesh

1 REPLY

Re: Problem in configuring port-channel between nexus and 3760 s

It could be a protocol mismatch/negotiation error or you have them in a state that will not bring the channel up, or you are not using the correct ports or an incorrect cable/speed/duplex/mdix issue.

Best test is

interface x/x

channel-group # mode on

On both sides, if it comes up cool - if not, then you need to check the cable/ports.

756
Views
0
Helpful
1
Replies