I have two ASR routers 1006 with IOS Version asr1000rp1-adventerprisek9.03.01.00.S.150-1.S.bin as mentiond in the attached files
ASR-A and ASR-B My problem i need to bring the link up between two routers connected with fiber link through DWDM in the physical interfaces not in the subinterfaces as mentiond below and attached in the files
Find below router specs when i removed the configurtion from the subinterface and pasted in the physical interface
iam not able the ping the ip address and the ospf neighber ship and mpls went down its only work in the subinterface
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...