03-16-2008 11:54 PM - edited 03-03-2019 09:09 PM
My router does no load the image . At the attachments you can see all the output.
What shall i do?
Thanks a lot
moses
03-17-2008 12:07 AM
HI Moses, [Pls Rate if HELPS]
This message only occurs when you load images that run from RAM. Cisco 1700 Series routers support images that run in RAM and images that run directly from Flash (for example, relocatable images), there are two solutions for this problem:
1. Upgrade the DRAM
2. Load a relocatable image; load an image from Flash
Refer LINK Below:
====================
http://www.cisco.com/en/US/products/hw/routers/ps221/products_tech_note09186a008009483a.shtml
Hope I am Informative.
PLS RATE if HELPS
Best Regards,
Guru Prasad R
03-17-2008 12:20 AM
Hi and thanks. I wrote the command
rommon 8 > boot flash:c1700-advsecurityk9-mz.124-17.bin
but i have the same results.
The flash is this
rommon 7 > dir flash:
File size Checksum File name
13707088 bytes (0xd12750) 0xbd90 c1700-advsecurityk9-mz.124-17.bin
thanks
moses
03-17-2008 01:08 AM
HI Moses, [Pls Rate if HELPS]
I don't thinkso your Router is capable of booting on Image c1700-advsecurityk9-mz.124-17.bin
> It doesn't have enough RAM available to load on the new Software
Read the release notes below:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/1700/1700rlsn/index.htm
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/1700/1700rlsn/index.htm
PLS RATE if HELPS
Best Regards,
Guru Prasad R
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: