I wish that since my lan when I enter my publicip address with port I?m redirect towards the nat which correpond with the interface wan.
My router is configured for nat since the interface Wan port 80 towards private address IP 192.168.1.9: 80. I wish that when I type the Ippublique address: 80 since my lan that is redirected towards the nat correpondant lan with the 192.168.1.9 address: 80.
I wish that if my nat on the interface Wan with port 6589 is configured for router on the local address 192.168.1.15 : 56, that when I type my ippublic address with port 6589 since my lan that I is directly to redirect towards the address room corresponds 192.168.1.15: 56.
I have to test on several occasions different config but ever succeeded. Best will be than the rule is dynamic that wants right statement than this ?loopback? between interface is automatically realizable on all the redirections of port between the interface wan and lan interfaces it.
yes i'am in the case there is no internal DNS server. my Dns server is the dns of my ISP i give you a little shema. ( shema. jpg)
i'am connected on the web server with the host D: i see my webpage with ip adresse public ( 184.108.40.2066:80) the router is configured for natting the 220.127.116.11:80 on the 192.168.1.10:80. All it's ok i can see my web page.
now i want to see my page with the host A but with the external adresse ( 18.104.22.1686:80 ). I am on the host A, i open my web browser and i want to see the web page in the server web by the adresse 22.214.171.1246:80. When i enter this adresse in the browser of the host A they have ? message : ERROR 404 by internet explorer. I look for an acl or what ever for redirected automatiquely the traffic with the rules of nat.
This behavior are configurated automatiquely in the factory settings on Linksys router WAG54G.But i can't find this configuration on a Cisco 877.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...