If it is a basic config and you just want to get ip route for ospf to show up then do couple of simply task:
make sure the 4 routers are able to ping each other's directly connected link and then configure ospf like:
router ospf 1
net 0.0.0.0 255.255.255.255 a 0
let me know how you get on!
thanks for u help !
So, i add this network with my other network or on my 4 routers i have just this rules on my ospf configuration ?
i clear my ospf, and i recreate my ospf juste with net 0.0.0.0 255.255.255.255 a 0" but know just two router have the route. I feel, pt is time to time totally random...
I talk about interface address. Use "show ip ospf" command to look ospf proccess id.
OSPF chooses proccess id by:
1. Highest ip address of loopback;
2. Highest ip address of physical interface.
omg, work perfectly :D
So i've another question but it's not about ospf but about the stp (i know i'm on the wan section but, i ask my question anyway :D)
on my PT, on my switch0, "spanning-tree vlan 1-8 priority 61440" and "spanning-tree vlan 1-8 root primary" with this all of pc port in portfast, it's sufficient for a correct spannin-tree ? (beginner)
Thanks a lot Kirill !