Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem with IOS Upgradation

I am trying to upgrade IOS of Cisco 3845 router.But after upgrading IOS from c3845-ipbase-mz.124-3b to c3845-spservicesk9-mz.124-17 it gives error when reload "fail to access file c3845-spservicesk9-mz.124-17" and boot with old IOS.Router have sufficient memory 256 MB.

9 REPLIES

Re: Problem with IOS Upgradation

HI Arjun,

Problem could be because of error in the downloaded file.

Did the new File pass the Checksum. Try to re-download the file and do it.

Pls Rate if HELPS

Best Regards,

Guru Prasad R

New Member

Re: Problem with IOS Upgradation

I try re-download three times with different tftp.But it remains same.

Please help me.

Silver

Re: Problem with IOS Upgradation

Hi Arjun ,

have you given .bin extension while loading the IOS.Can you paste the show version and show flash output.

check the show run for boot system flash line.

and try to execute following commands.

no boot system flash:old image name

boot system flash:new image name.

do the above if the new image passes checksum means no error noticed while loading new image.

Thanks,

satish

New Member

Re: Problem with IOS Upgradation

I tried these command:no boot system flash:old image name

boot system flash:new image name

It still give error.

For upgrading I give copy tftp flash command.

Please tell me if there is any another process for specific Cisco 3845 router.

Please see attachment for version.

New Member

Re: Problem with IOS Upgradation

hi

You may need to delete the old ios before upgrade.Bcos, sp services file may not fit with ip base in the same flash.. cos ur flash is only 64MB

Cheers!

New Member

Re: Problem with IOS Upgradation

you may post the output of dir command even before carrying out the above task

New Member

Re: Problem with IOS Upgradation

my old IOS is 17MB and New IOS is 27 MB.so i think 64mb is sufficiant for both IOS.

can you tell me the proper procedure for upgradation verification.

Hall of Fame Super Silver

Re: Problem with IOS Upgradation

Arjun

Would you post the output of show flash and the output of show run | include boot? It would also be helpful if you could post the error message exactly from the boot process. I am wondering if there is a mismatch (or mis-spelling) of the name in the boot statement with the file name in flash.

HTH

Rick

Silver

Re: Problem with IOS Upgradation

Hi Arjun ,

Yes , you can load the ios using xmodem procedure.But it takes time and depends on the size of the IOS which you trying to load.

Check out below link.

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml

Thanks,

satish

139
Views
0
Helpful
9
Replies