I have a PA-8E that when I insert in a new 7200VXR router show me some errors like this :
%PA-3-REVNOTSUPPORTED: PA in slot2 (Ethernet) requires base h/w revision of (1.14) fo
I searched in cisco and found that it is related to my module firmware ver . my firmware rev is 1.11 and documents show me that it must be at least 1.14. now is it possible to update my PA firmware ? if yes how can I do it?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...