Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Problem with PPPOE in 1800 router

                   Hi

when I'm trying to configure my router 1801 with PPPOE  I have the message below

"

% PPPoE config from vpdn-group is converted to pppoe-profile based config.

% Continue PPPoE configuration under 'bba-group pppoe global'

My config is : 

vpdn enable 

vpdn-group PPPOE 

accept-dialin 

protocol pppoe 

virtual-template 1

help me to understand this kind of message and to solve this problem.

best regards.

2 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Problem with PPPOE in 1800 router

Hi,

Command syntax was changed with the code at some point and the message you are getting informs you that you should you a new set of commands, as PPoE configurations under vpdn-group were transitioned to bba-group.

Note that it does not simply deny your command but converts them automatically to new format and puts into configuration.

In overall, instead of:

    vpdn-group PPPOE

       accept-dialin

         virtual-template 1

         protocol pppoe

       pppoe limit per-... ...

you should use:

     bba-group pppoe global

       virtual-template 1

       sessions per-... ...

and that will resolve your issue.

Kind Regards,
Ivan

**Please grade this post if you find it useful.

Kind Regards, Ivan Shirshin **Please grade this post if you find it useful.
Cisco Employee

Problem with PPPOE in 1800 router

welcome, Adhane. I would appreciate if you could mark the post if it was helpful and close the thread (mark correct answer :-) ).

Kind Regards, Ivan Shirshin **Please grade this post if you find it useful.
3 REPLIES
Cisco Employee

Problem with PPPOE in 1800 router

Hi,

Command syntax was changed with the code at some point and the message you are getting informs you that you should you a new set of commands, as PPoE configurations under vpdn-group were transitioned to bba-group.

Note that it does not simply deny your command but converts them automatically to new format and puts into configuration.

In overall, instead of:

    vpdn-group PPPOE

       accept-dialin

         virtual-template 1

         protocol pppoe

       pppoe limit per-... ...

you should use:

     bba-group pppoe global

       virtual-template 1

       sessions per-... ...

and that will resolve your issue.

Kind Regards,
Ivan

**Please grade this post if you find it useful.

Kind Regards, Ivan Shirshin **Please grade this post if you find it useful.
New Member

Problem with PPPOE in 1800 router

Thanks Ivan , It's Ok for me now.

Cisco Employee

Problem with PPPOE in 1800 router

welcome, Adhane. I would appreciate if you could mark the post if it was helpful and close the thread (mark correct answer :-) ).

Kind Regards, Ivan Shirshin **Please grade this post if you find it useful.
305
Views
0
Helpful
3
Replies
CreatePlease to create content