Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Problem with PRI Drop-and-Insert

Hello,

We use 2 PABX connected to each other via PRI. Config 2811(please see attached the file) is set between. We have attempted to send PRI via 2811 using Drop-and-Insert. Diagnostic commands do not show any error messages however PABX do not "see" each other.

Could you please give your kind comments how to solve the issue or address me to the right contact.

your prompt response will be highly

2 REPLIES
Hall of Fame Super Silver

Re: Problem with PRI Drop-and-Insert

Hello Anton,

E1 D channel should be 15 not 16

I think you need to cross-connect timeslot 15 not 16

Hope to help

Giuseppe

Hall of Fame Super Silver

Re: Problem with PRI Drop-and-Insert

Hello Anton,

I've confused the cisco indexes for interfaces that starts with 0.

timeslot 16 should be fine.

there are additional options for the commands like

tdm-group

tdm-group-no

timeslots timeslot-list type [e&m | fxs

[loop-start |

ground-start] fxo [loop-start |

ground-start]

see

http://www.cisco.com/en/US/docs/wireless/mwr_1941/software_configuration/current_scg/DCNcfg.html#wp1109831

but I don't think this applies to you.

Sorry for the confusion

Hope to help

Giuseppe

139
Views
0
Helpful
2
Replies
CreatePlease to create content