Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Silver

problem with route-map binding

I have a peer-group template and neighbors are binded in that template.

when i mention the command of route-map for a particular neighbor and that neighbor is also binded with the peer-group, in this case i am not able sepecify the out but in is working.

regards

shivlu

  • WAN Routing and Switching
5 REPLIES

Re: problem with route-map binding

You should bear in mind that a peer group is much more than just a template.

One of the main features of a peer group is that you must have the same outgoing policies for all the peers in the group. The idea behind the peer group is to save CPU time by compiling one set of updates only, and sending it to each of the peers in the group. Of course, for this to be viable, the outgoing route-map must apply to all peers in the group. That is why it will not allow you to attach the route-map to only one peer.

Kevin Dorrell

Luxembourg

Hall of Fame Super Silver

Re: problem with route-map binding

Kevin

Nice explanation. It deserves the rating that I gave it.

Congratulations on achieving your CCIE.

HTH

Rick

Re: problem with route-map binding

Thank you Rick, for both!

Re: problem with route-map binding

Dear Kevin,

Congratulations on achieving your CCIE.

Best Regards,

Guru Prasad R

Re: problem with route-map binding

Thank you Guru!

104
Views
5
Helpful
5
Replies