Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem with router 1841 and Module card Hwic-1FE

Dear All,

Could you tell me please, i have router cisco 1841 and Module card Hwic-1FE.when plug Hwic-1FE to router and i type command show run i don't see interface Hwic-1FE on Router 1841.What is going on ?

Note:i used this IOS : c1841-ipbase-mz.124-1c.bin

Best Regards,

Rechard

3 REPLIES
Hall of Fame Super Gold

Re: Problem with router 1841 and Module card Hwic-1FE

You need a later IOS for that card, I recommend 12.4(11)XJ4.

If you don't have the support contract required to download the image from CCO, either buy a service contract or ask who has sold you router/card to provide it to you.

Hope this helps, please rate post if it does!

New Member

Re: Problem with router 1841 and Module card Hwic-1FE

Dear sir,

Thank you for your advices!!!

Ok i understood. Could you give more detail part number that can support command load balancing.

one more when i plug card to the router are three LEDs port is up(mean light is on are three port are up)

Note: i not yet plug network cable to module card.

Best Regards,

Rechard

Hall of Fame Super Gold

Re: Problem with router 1841 and Module card Hwic-1FE

No part numbers. Load balancing is embedded in IOS and just a matter of configuration.

As a recognition to those providing answers, please rate useful posts with the scrollbox below!

351
Views
4
Helpful
3
Replies
CreatePlease to create content