Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem with setup of 1841 router

During initial setup of 1841 router, after I logged in as initial user(cisco), there were power brake down, so my pc and router restarts. Problem is I didn't manage to create new user, so now I cannot login to route. Is there any way to create user now, so that i can configure router?

Thank you

2 REPLIES
Hall of Fame Super Silver

Re: Problem with setup of 1841 router

Predrag

As far as I know in your situation you need to perform password recovery to get into the router. After password recovery is done and you are in the router in enable mode you could load the startup config if you wish, or you can just start configuring the router from scratch.

I recently ran into a very similar situation where we had not created a new user iD and password, and the password recovery worked very well for us.

HTH

Rick

New Member

Re: Problem with setup of 1841 router

Thank you Rick very much, for advice. i will do that.

272
Views
0
Helpful
2
Replies