Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem with VLAN Going in shutdown mode after power On

I have one cisco switch series 3500 and I am facing the problem with the VLAN.

Once I configured it and saved all the config,and after that If I power off the switch and then again power on the switch ..its VLAN goes in shut down mode.I have rechecked it again all teh config and again made the VLAN no shut..and when Once again I did the same thing power Off and On the VLAN goes again in shut down mode..>can any one please help. It SW version is 12.0(5)WC13.

8 REPLIES
Silver

Re: Problem with VLAN Going in shutdown mode after power On

Is there any port belongs to that vlan? If not that might be a problem.

New Member

Re: Problem with VLAN Going in shutdown mode after power On

yeah we have few port is belong to that vlan

Hall of Fame Super Blue

Re: Problem with VLAN Going in shutdown mode after power On

Hi

Can you post config of switch.

Is this switch acting as a layer 2 or layer 3 switch ?

Jon

New Member

Re: Problem with VLAN Going in shutdown mode after power On

IT is acting as layer 2.

kindly understand the things from the attached mail ..this is the switch swutc1..

waiting for ur response ASAP..JON

Silver

Re: Problem with VLAN Going in shutdown mode after power On

Are they up or admin down?

New Member

Re: Problem with VLAN Going in shutdown mode after power On

It is UP but..see if anytime the power goes off the VLAN goes in shutdown..and again through console we have to log in and we have to make it ..no shut..and it starts working..but again if we power off the switch again it goes in shutdown..then again we have to take to console and make it up

New Member

Re: Problem with VLAN Going in shutdown mode after power On

Hi

Looking at the configuration file u have attached, i c a shutdown command at the end of the interface configuration

ur config:

interface VLAN2

ip address 10.30.130.101 255.255.0.0

no ip directed-broadcast

no ip route-cache

shutdown

- - - - -

Do a no shutdown to the vlan interface and then copy the config to startup config ... and then reboot ur switch and check ...

hope this helps u ....

New Member

Re: Problem with VLAN Going in shutdown mode after power On

as the switch is at customer end I will try this once i go ther and will let you know..

lets see if this works..

214
Views
0
Helpful
8
Replies
CreatePlease to create content