Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem with Wic-2AM

Dear ALL,

Please help me,On my current system i had Router 2811, wic-2Ta/s(use on slot 0) and N/M 8am,and i bought two more card Wic-2Am.

The problem when i plug the new card (Wic-2AM) in to the router i doesn't know interface.I don't know why?

Note:on Wic-2T and Slot 0 it show like this(s0/0/0 and s0/0/1) and Card NM 8AM it show interface like this( int as1/0,1/1,1/2,1/3,1/4,1/5.1/5,1/7.And the new card i plug on slot1 and slot2 but it don't show interface as

Please see in the attach file.

Best Regards,

Norung

1 REPLY
New Member

Re: Problem with Wic-2AM

not able to see any attached file.

Possibilities as below,

1. Please check in case the existing IOS supports the new card

2. Try inserting the existing card in slot1 or 2 just to ensure that the slots r working fine

111
Views
0
Helpful
1
Replies