I have a Catalyst 3560G series switch purchased brand new, well 3 actually. I can telnet in and have assigned IP addresses but I'd also like to turn on the multicasting function. I have browsed this site and found the command ip multicast-routing distribute and have tried that to no avail. I keep getting an error at the multicast.
Is there any preconfig that I should be doing prior to this? I'm in at EXEC level.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...