Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
252
Views
0
Helpful
2
Replies

Problems when configuring E1 controller

glenn.guzman
Level 1
Level 1

‎08-01-2007 09:14 AM - edited ‎03-03-2019 06:08 PM

I have a 3640 router. I also have a VWIC-MFT-E1 card and Im trying to setup a ppp connection to a branch office. I have configure the E1 controller and assigned an ip address of 192.168.200.9/30 to serial interface "serial 0/2:0" but Im not able to ping the directly connected interface even though is up and up.

ideas ?

Labels:
Preview file
1 KB
Preview file
2 KB
Preview file
1 KB
0 Helpful
2 Replies 2

glenn.guzman
Level 1
Level 1

‎08-01-2007 09:15 AM

Thanks to everybody

0 Helpful

royalblues
Level 10
Level 10
In response to glenn.guzman

‎08-01-2007 12:14 PM

Can you post the router config on the other side?

BTW your output shows that the serial link is HDLC as opposed to PPP?

What interfaces are part of the multilink?

Narayan

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card