08-01-2007 09:14 AM - edited 03-03-2019 06:08 PM
I have a 3640 router. I also have a VWIC-MFT-E1 card and Im trying to setup a ppp connection to a branch office. I have configure the E1 controller and assigned an ip address of 192.168.200.9/30 to serial interface "serial 0/2:0" but Im not able to ping the directly connected interface even though is up and up.
ideas ?
08-01-2007 09:15 AM
Thanks to everybody
08-01-2007 12:14 PM
Can you post the router config on the other side?
BTW your output shows that the serial link is HDLC as opposed to PPP?
What interfaces are part of the multilink?
Narayan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: