Cisco Support Community
Community Member

Problems with Connecting WAP4410N with 2 SSID to Catalyst 2960-s Switch

Hi all,

Just need some assistance from you guys for the issue as mentioned in the title, I have problems with connecting WAP4410N with 2 different SSID (Staff & Guest) to Catalyst 2960-S series switch. 

Devices in hand:

1. One unit of WAP4410N

2. One unit of Catalyst 2960-s Series Switch

3. One unit of Unifi modem (ZTE ZXDSL931) **Specific modem which support fibre backbone

4. One unit of Unifi supported wifi router (D-Link DIR-615) **Supported Dynamic PPPOE Protocol

Connection between devices:


From the image above, I need to create 2 different SSID from WAP4410N (staff & guest).

** Guest SSID will be isolated from all LAN devices.

** Guest SSID will be only allowed to access to the internet.

I had already configure Cisco switch catalyst 2960-s and configuration as below:

** Two trunk port created for the connection from (2960-s to 4410N) and from (2960-s to D-Link DIR-615)

** First VLAN created with VLAN ID 10 and it would carry "Guest" SSID

** "Staff" SSID will use the default VLAN which is VLAN 1.

As the information given by cisco support engineer, Unifi Router (D-Link DIR-615) need to support multiple VLAN subnet.

Unfortunately, D-Link DIR-615 above does not support multiple VLAN subnet.

So, is there any other way i can do to achieve my goal with the existing devices on hand?

Your help is highly appreciated.


CreatePlease to create content