I use a application in cluster, only 1 connection each time.
The problem is: Server 1 connected, i take off the network cable from the macchine then the another side send me a packet from the X.25 and the router try to send it to Server 1 but it's off and he continues retrying to send the message for 18 times(7:30 minutes approximately)
and only after this the router disconnect the tcp connection and the x.25 connection.
While this connections are stuck in the router I can't up the Server 2.
I think it's a "tcp timeout parameter". Can I decrease this number of retries of the tcp packet?
It always disconnect after 18 retries.
Doesn't matter if a try to up the Server 2 before the 18 retries, the other side only accept one connection at the same time.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...