Recently Comcast made some changes over here on the East coast and since then my Internet connection just stops working. I am at about once every other day.
Here is my current config for the Outside interface of my 2800 series router.
description Connected to the Internet
ip dhcp client client-id Loopback0
ip address dhcp
ip access-group 102 in
no ip redirects
no ip unreachables
no ip proxy-arp
ip nat outside
ip inspect SDM_LOW out
ip route-cache flow
no cdp enable
My static route is now set to this
ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/0 dhcp
What I do to fix the issue is shut/no shut on the gig0/0 port.
Is this the correct setup for a DHCP style internet connection? I know that you want to set the static route to the next hop address IF you can, but for me that address could change, so I believe the DHCP command takes care of any arp issues that I would have with the static route using my outside interface.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...