Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PVC's not showing in routing table in Frame Relay

Hello,

I have a frame relay setup where there are three routers connected to a Frame Relay Cloud and each router is connected to one another by a PVC that I have created using sub interfaces on each router.  My question is, when I do a show IP Route, I do not see the PVC's listed in the routing table.  The routing table is blank.  I have attached my Packet Tracer File.  Can anyone please shed some light on this for me?  I have investigated this for much time and cannot find any resolution.

Thanks.

1 REPLY
New Member

PVC's not showing in routing table in Frame Relay

Hey Marc,

I looked over your packet tracer and you have everything on the routers configured correctly. The problems were with the "ISP" cloud device:

  • Created Frame-Relay Mappings on the Cloud Device. (Allowed Data to traverse the network through the "ISP" Cloud Device)
  • Adjusted the LMI types on the cloud device to ANSI (Brought Serial connections up)

Hope this helps

131
Views
0
Helpful
1
Replies
CreatePlease to create content