Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

pvdm prob with bri module

WE HAVE THE FF;

3825

WIC-4B S/T

PVDM2-12DM

OBJECTIVE;

To accept analogue calls from a remote 3825 having 2 analogue lines.

FINDINGS

Cannot establish calls

I found out that PVDM modules only supports e1/t1 modules and not the bri's. But pvdm modules are replacement for the old eos digital modem network modules (NM-6D etc)

in this case, what will be the workaround solution. Will the NM-6d still supported on the new 3800 series router?

thanks

2 REPLIES
Silver

Re: pvdm prob with bri module

I think PVDM slots accommodate digital-signal-processor (DSP) modules for packet voice processing and Local or long-distance calling with the EVM module-Up to 48 foreign exchange office (FXO) or 32 Basic Rate Interface (BRI) ports can be supported.

Hall of Fame Super Gold

Re: pvdm prob with bri module

Hello,

the PVDM2-xDM works only and exclusively together with PRI Network Modules:

http://cisco.com/en/US/products/ps5854/products_data_sheet0900aecd8050918e.html

The Cisco Digital Modem PVDM Modules operate in conjunction with the following Cisco

Network Modules:

* NM-1CE1T1-PRI (1-Port Channelized E1/T1/ISDN-PRI Network Module)

* NM-2CE1T1-PRI (2-Port Channelized E1/T1/ISDN-PRI Network Module)

So, no matter the BRI modules installed, it will never work with the Digital Modems.

Hope this helps, please rate post if it does!

114
Views
0
Helpful
2
Replies