Does anyone know of any application (Cisco or otherwise) that can do the pre-policy and post-policy traffic graphs that QDM (and QPM for that matter) used to do? I haven't worked too much with ASDM yet. I suppose I could get MRTG to do it if I found the MIB variables to use but that's non-trivial.
QDM provides graphs for the interfaces, subinterfaces, traffic policies, and traffic classes. For each graph, there may be several graph lines. For example, the graph on the interface packet counts show four graph lines, one on the input packet output, the output packet count, the input drop packet count, and the ouput drop packet count
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...