Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QoS between two catalysts 3750

we are running a transparent 2Mbit L2 link between two sites with a catalyst 3750 on each (connected to a fast ethernet port)

we want to implement qos to priorize 320Mbit for EF and 600 Mbit for AF3.

the EF packets are already marked; the packet for the AF3 have to be marked first.

Has anyone done already a similiar setup?

2 REPLIES
Hall of Fame Super Silver

Re: QoS between two catalysts 3750

Hello Frank,

if you are using bridging over a WAN link and no L3 device is involved you can try to take advantage of SRR queueing in C3750

>> In shaped mode, the egress queues are guaranteed a percentage of the bandwidth, and they are rate-limited to that amount. Shaped traffic does not use more than the allocated bandwidth even if the link is idle. Shaping provides a more even flow of traffic over time and reduces the peaks and valleys of bursty traffic. With shaping, the absolute value of each weight is used to compute the bandwidth available for the queues.

see

http://www.cisco.com/en/US/partner/docs/switches/lan/catalyst3750/software/release/12.2_46_se/configuration/guide/swqos.html#wp1200681

the shaped mode should be the one that fits your needs.

you need to configure appropriate marking on ingress interfaces

Edit:

with routers you could use hierarchical QoS shaping all traffic to 2 Mbps and invoking a child policy with a scheduler.

with C3750 switches you may be able to find only an approximate solution

Hope to help

Giuseppe

New Member

Re: QoS between two catalysts 3750

Hi Giuseppe,

thanks for your answer. It confirms the results of my "studies" that the 3750 is not the most flexible platform for QoS.

regards

frank

127
Views
0
Helpful
2
Replies
CreatePlease to create content