Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

QoS for Internet Link (DSL)

Dears;

we have an internet link 2 Mbps and i want to do a QoS for the email traffic, so i want to reserve 1 Mbps from the incoming and outgoing emails. please advice with the configuration lines. the email servers are 172.16.20.20 and 172.16.20.21 the current configuration of the router as the following:

!
vpdn enable
!
vpdn-group 1
request-dialin
  protocol pppoe
!
!
!
!
!
archive
log config
  hidekeys
!
!
!
!
!
interface FastEthernet0/0
description Connected to LAN
ip address 172.16.20.1 255.255.255.0
ip nat inside
ip virtual-reassembly
duplex auto
speed auto
!
interface FastEthernet0/1
description connected to the modem (ISP)
bandwidth 2048
no ip address
duplex auto
speed auto
pppoe enable group global
pppoe-client dial-pool-number 1

!
interface Dialer1
bandwidth 2048
ip address negotiated
ip mtu 1492
ip nat outside
ip virtual-reassembly
encapsulation ppp
no ip mroute-cache
dialer pool 1
dialer-group 1
no cdp enable
ppp authentication pap callin
ppp chap refuse
ppp ms-chap refuse
ppp pap sent-username sss@ssss.com password 7 101F5B4A5142
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 Dialer1
no ip http server
no ip http secure-server
!
!
ip nat inside source list 1 interface Dialer1 overload

//natting for the email servers
ip nat inside source static 172.16.20.20 83.101.100.101

ip nat inside source static 172.16.20.21 83.101.100.102

!
!
access-list 1 permit any
dialer-list 1 protocol ip permit
!
!

Message was edited by: kayocisco

2 REPLIES

Re: QoS for Internet Link (DSL)

Dears;

we have an internet link 2 Mbps and i want to do a QoS for the email traffic, so i want to reserve 1 Mbps from the incoming and outgoing emails. please advice with the configuration lines. the email servers are 172.16.20.20 and 172.16.20.21 the current configuration of the router as the following:

!
vpdn enable
!
vpdn-group 1
request-dialin
  protocol pppoe
!
!
!
!
!
archive
log config
  hidekeys
!
!
!
!
!
interface FastEthernet0/0
description Connected to LAN
ip address 172.16.20.1 255.255.255.0
ip nat inside
ip virtual-reassembly
duplex auto
speed auto
!
interface FastEthernet0/1
description connected to the modem (ISP)
bandwidth 2048
no ip address
duplex auto
speed auto
pppoe enable group global
pppoe-client dial-pool-number 1

Hi,

For your information QoS doesn't interact unless there is congestion on the link,First Define the classes (for mail use the protocols like pop3 or smtp)

class-map match-any mail
match protocol pop3
match protocol smtp
match protocol imap
match protocol secure-pop3
match protocol secure-imap
match protocol exchange
match protocol ldap

Assign each traffic class the appropriate bw:
policy-map qos
class mail
bandwidth percent 50
class class-default
fair-queue


Apply the policy under each interface in the output direction:
interface serial 0/0
bandwidth 2048
service-policy output qos

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

New Member

Re: QoS for Internet Link (DSL)

Dears;

this is about outgoing emails, what about the incoming email? can i do QoS for incoming emails too?

Thanks;

Kayo

515
Views
4
Helpful
2
Replies